Sharp TM200 Service Manual page 25

4-8-1. Main back light check
The main display backlight turns on and the message appears on the PC.
TM200
Check the backlight and press "OK".
• If a failure occurs, see "10. Back Light does not turn on." in [3] Trou-
bleshooting.
4-8-2. External back light check
The external display back light turns on and the message appears on
the PC. Check the back light and press "OK".
• If a failure occurs, see "10. Back Light does not turn on." in [3] Trou-
bleshooting.
4-8-3. Key back light check
The keypad back light turns on and the message appears on the PC.
Check the back light and press "OK".
4-8-8. Melody test
A message describes test items. Click "Yes" to proceed and "No" to exit.
The order of the test items:
speaker 3 hands free 3 hands free (stereo) 3 speaker (analog melody)
Trouble found by SPST
(1) Speaker
(2) Hands free Sound is heard in audio test.
No sound is heard in audio test.
(3) Hands free (stereo) Sound is heard in audio test.
No sound is heard in audio test.
(4) Speaker (analog melody)
4-8-9. Audio test
The following appears.
Select a test item from Audio device. Check the output sound from the
receiver by speaking to the microphone, etc. Click "Back to test menu"
to return to the previous screen.
CONFIDENTIAL
See "Speaker does not work."
Parts between IC105 pin 10 and IC103 pin 93 are defective, or IC103 is defective.
See "Hands free kit (monaural headset)" in the section "3. No voice is heard from the earpiece."
Parts between IC105 pin 10 and IC103 pin 93; IC105 pin 11 and IC103 pin 94 are defective.
Otherwise IC103 is defective.
See "Hands free kit (stereo headset) - Option "in the section "No voice is heard from the earpiece."
See "Video/Voice Recorder playback is impossible."
Otherwise parts between IC105 pin 10 and IC103 pin 93 are defective, or IC103 is defective.
TM200 1ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
2 – 21
4-8-4. LED check
The LED lights up in a specified color and the message appears on the
PC. Check the LED and press "OK".
• If a failure occurs, see "15. Flash light does not work." in [3] Trouble-
shooting.
4-8-5. Battery voltage check
Click to display the current battery voltage.
• If a failure occurs, see "1. Power is not turned on." in [3] Troubleshooting.
4-8-6. SD read/write test
Insert an SD card (otherwise a message prompts you to do so and click
the button to perform the SD card read/write test.
• If a failure occurs, see "17. SD (Memory) card is not recognized." in
[3] Troubleshooting.
4-8-7. Vibrator test
Click to vibrate the handset. Click "OK" to exit.
• If a failure occurs, see "5. Vibrator does not work." in [3] Trouble-
shooting.
Troubleshooting (basedon [3] Troubleshooting)