Table of Contents
Advertisement
[Uninstalling the software]
1. Double click "setup.exe" in TM200 Install-E folder.
2. The Setup Wizard is activated. Select "Remove The TM200
Upgrading Tool" and click the "Finish" button.
TM200
TM200
TM200
TM200
3. Uninstalltion starts. The progress is displayed.
TM200
TM200
TM200
4. The uninstallation is completed. Click the "Close" button to close
the Setup Wizard.
TM200
TM200
CONFIDENTIAL
TM200
TM200 1ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
2) Connecting handset to a PC
A) Using a cable for upgrading
1. Connect the cable to a PC.
2. Connect the cable to handset.
3. The photo below shows handset connected to a PC.
B) Using Communication Box
1. Connect a PC to Communication Box via a serial cable.
2. Connect the AC charger to Communication Box and then plug it into
the outlet.
All SET POWER SW on Communication Box must be turned off.
3. Connect the conversion connector to Communication Box Cables.
Connect the conversion connector in the following order, label side up.
From upper right end: Cable No. 1, 3, 5, 7, and 9.
From lower right end: Cable No. 2, 4, 6, 8, and 10.
4. The photo below shows the conversion connector connected to
Communication Box Cable 1.
2 – 6
Advertisement
Table of Contents
