Texas Instruments TI-89 Manual Book page 242

Which Setup
Parameters to Use
Changing the
Setup Parameters
Tip: To cancel a menu or
exit the dialog box without
saving any changes, press
N instead of ¸ .
From the Home
Screen or a Program
To generate: tblStart
An automatic table
¦
Based on value
initial values
¦
That matches
Graph screen
A manual table
"—" means that any value entered for this parameter is ignored for
the indicated type of table.
In SEQUENCE graphing mode (Chapter 9), use integers for
and @tbl .
From the
TABLE SETUP
1. Use D and C to highlight the value or setting to change.
2. Specify the new value or setting.
To change:
tblStart
or
@tbl
Graph < - > Table
or
Independent
3. After changing all applicable values or settings, press ¸ to
save your changes and close the dialog box.
You can set up a table's parameters from the Home screen or a
program. You can:
¦
Store values directly to the system variables
Refer to "Storing and Recalling Variable Values" in Chapter 2.
¦
Set Graph < - > Table
function. Refer to Appendix A.
@tbl Graph < - > Table
value
OFF
— —
ON
— — —
dialog box:
Do this:
Type the new value. The existing value is
erased when you start to type.
— or —
Press A or B to remove the highlighting.
Then edit the existing value.
Press A or B to display a menu of valid
settings. Then either:
¦
Move the cursor to highlight the
setting and press ¸.
— or —
¦
Press the number for that setting.
and by using the
Independent
Chapter 13: Tables
Independent
AUTO
AUTO
ASK
tblStart
and @tbl .
tblStart
setTable
225