Texas Instruments TI-89VSC - Viewscreen Calculator Troubleshooting Manual

TroubleShooting the TI -89
CALCULATOR BATTERIES
Will I lose all my programs when I change batteries?
There is no guarantee that changing batteries will not reset your calculator's memory. However, a
method that seems to work well is to make sure your calculator is turned off, take the old batteries
out one at a time, replacing each with a new battery before removing the next. Be sure you have
the direction of the batteries correct (+ and – alternating).
What is the backup battery?
The backup battery is a round battery above the AAA batteries and under a piece of plastic that is
fastened to the calculator with a small screw.
How long will my batteries last?
How long your batteries last depends on how much you use your calculator. The four AAA bat-
teries in the calculator usually last for about a year with normal use in a calculus course. The
backup battery can last anywhere from 2 to 5 years.
When do I need to replace the batteries?
You need to replace the AAA batteries if your screen is not dark enough when you press
release that key, and then press and hold the + key. (See the second bulleted item under
diamond ,
the General category.) There is also a battery indicator in the lower-right hand corner of the home
screen that appears when your batteries need replacing.
I've replaced the four AAA batteries and my calculator still won't come on. What next?
Sometimes when you replace batteries, the calculator resets to its lightest screen setting. Darken the
display according to the directions given in the second bulleted item under the General category. If
you have replaced the AAA batteries, you have darkened the display, and your calculator still will
not turn on, it is likely that the backup battery needs replacing.
DELETING PROGRAMS OR OTHER INFORMATION FROM THE TI-89
How do I delete information from my calculator?
Press
2nd + [ MEM] 2 [ Delete]
For instance, to delete a program, press
the information you want to delete and press
command.
The calculator keeps giving me a memory error when I try to enter data or transfer or run a
program. What can I do?
Press . If you have approximately 8000 or less in the
2nd 6 [ MEM]
to delete some of the calculator's contents. Pictures (
lot of room and can be deleted by following the directions in the answer directly above. Game
programs also take up a lot of room and create some of the pictures and data bases that may be
stored in your calculator.
I'm trying to delete data in one of the cells of the data/matrix editor and nothing happens.
If the data entry does not delete when it is highlighted and you press
locked. If you entered the data using the sequence command and/or aligned or shifted the data by
adding/ subtracting/multiplying, and so forth, there is a picture of a lock next to the row and
column number of the entry at the bottom of the data editor screen. When the data is locked this
TI 89-106
Next press the number corresponding to what you wish to delete.
.
Use the down arrow to move the cursor next to
7 [ Prgm] .
Be very careful – there is no "undo"
ENTER .
PIC
Copyright © Houghton Mifflin Company. All rights reserved.
location, you need
RAM FREE
) and graph data bases (
,
back arrow
green
) take up a
GDB
the data may be