SC826 Chassis Manual
Add-on Card Setup (SC826 RC chassis - OEM Only)
SC826 chassis RC models allow for up to 3 full height/full length card slots. RC2
allows up to 3 full height/full length card slots and up to 3 low profile cards slots.
Figure 4-8: 3 Full Height/Full Length with 3 Low Profile Slot
To install add-on to an RC version chassis:
1.
Confirm that the motherboard was installed correctly.
2.
You must install add-on cards to the butterfly bracket. To do this:
a. Make sure each add-on card includes a "L" bracket. The "L" bracket
should be included by the add-on card manufacturer.
b. For each add-on, slide the card into the bracket until it clicks into place.
3.
Slide the riser card into the chassis, aligning with both the motherboard slot
and the back panel of the chassis.
Butterfly Bracket (Rear View)
4-10