NAIM NAIMUNITI Manual page 6

Na im Un it i In sta l la ti on a nd C onnec tion
2.9.2 Wireless Network Connection
If NaimUniti is to connect wirelessly to the home network
the supplied WiFi antenna must be fitted to the rear panel
wireless antenna socket. Wireless configuration will also
be necessary before NaimUniti is able to connect to the
network. See Section 4.6.1 of this manual.
2.9.3 Network Settings
NaimUniti is set up when originally shipped not to require
any on-site network configuration but to connect to a
network automatically (it uses DHCP by default). However,
if your NaimUniti has been previously used, its network
configuration may have been altered leaving it unable
to connect automatically. If this appears to be the case
ensure that DHCP is selected in the Network Settings menu
and re-start NaimUniti. If problems still persist contact your
retailer, installer or Naim Audio directly. See Section 4.6.
Note:
A NaimUniti switched on without a working wired
network connection will only be able to connect to
a home network wirelessly. To use an ethernet (wired)
connection, switch NaimUniti off, connect the network and
switch it on again.
Note:
For internet radio to operate NaimUniti requires
connection to a broadband internet service via a router/
modem with a built-in firewall.
2. 1 0 Cont rol So c ke ts
NaimUniti is fitted on its rear panel with a standard
RS232 interface socket and a
sockets enable NaimUniti to be integrated within home
automation systems. Contact your retailer, distributor or
Naim for more information if required.
E4
Remote in socket. These