Installing The Canopy And Canopy; Trim Ring - Hunter 20552 Owner's Manual And Installation Manual

5 • Installing the Canopy and Canopy Trim Ring
5-1 . Holding the canopy, raise the fan off the hook .
5-2 . Align the slots in the canopy with the tabs on the ceiling plate .
5-3 . Raise the canopy over the ceiling plate . Rotate the canopy
clockwise until the tabs on the ceiling plate totally engage with
the slots in the canopy .
5-4 . Partially install the three canopy screws into the canopy one at a
time . Once all three screws are in, tighten them .
5-5 . Using both hands, push the canopy trim ring up to the top of the
canopy . The canopy trim ring will snap and lock into place .
Should you need to remove the canopy
trim ring, follow these steps:
1 . Locate the tab indicators, small
bumps on top of tabs .
2 . Press firmly on opposite sides of the
ring toward the canopy . The tabs will
flex out releasing the trim ring from
the canopy .
Canopy
Screw
10
42751-01 • 08/12/10 • Hunter Fan Company
Step 5-2
Ceiling Plate
Canopy Trim
Canopy
Steps 5-4 – 5-5
Ring
Step 5-3