Panasonic Document Management System; Setting The Network Parameters; Setting The User (Network) Parameters - Panasonic UF-4500 Operating Instructions Manual

Panasonic Document Management System (UF-5500 Only)

Setting the Network Parameters

Setting the User (Network) Parameters

For your machine to be able to operate on the Network properly, the following three (3) Basic Parameters
must be pre-programmed into the machine. (For UF-5500 only)
If DHCP server is available on your network, the IP Address, Subnet Mask and Default Gateway IP Address
will be acquired automatically.
• IP Address
• Subnet Mask
• Default Gateway IP Address
If the DHCP Server is not available, change the setting of the Fax Parameter No. 169 (DHCP CLIENT) to
"INVALID", and then enter the IP Address instead.
1
2
3
4
5
6
7
NOTE
138
7
1
Enter the Key Operator Password.
repeatedly until display shows;
Enter the IP Address using the keypad. Press
period ".". (See Note 2)
Ex:
1 2 3 1
1. To scroll the display to desired User Parameter in Step 5, press
2. For convenience, you can use
Otherwise is used to enter an asterisk under other conditions.
0
7 8 2 4
to enter a period "." while programming IP Addresses only.
SET MODE
ENTER NO. OR
USER PARAMETERS?
PRESS SET
KEY OPERATOR ID
ENTER ID=
KEY OPERATOR ID
ENTER ID=******
IP ADDRESS
IP ADDRESS
to enter the
123.178.240.3
3
SUBNET MASK
or
(1-8)
∨∧
.