Canon B45 - Faxphone B45 Bubble Jet Fax Machine Setup Sheet page 6

Set the fax receive mode.
Your fax provides you with several modes for receiving documents. Press [Receive Mode]
until the mode you want appears, then press [Start/Copy].
To determine which mode best suits your requirements, see the table below.
Receive Mode Main Use Operation
FAX/TEL AUTO SW Fax/Tel
(Fax/Tel Mode)
MANUAL MODE Tel
DRPD Fax/Tel
FAX ONLY MODE Fax
Set the built-in answering machine (TAM MODE).
Setting TAM MODE allows you to receive telephone messages and fax transmissions
while the fax is unattended. Before you use TAM MODE, you must record an outgoing
message. Use the microphone on the operation panel to record your outgoing message.
1 Use [3] or [4] to select OUTGOING MESSAGE.
2 Press [Record] and speak into the microphone to record your outgoing message.
The remaining recording time is displayed on the LCD. Only one outgoing message, no longer than 20
seconds, can be recorded.
TIME LEFT
19
3 Press [Stop] twice when recording is finished.
Automatically switches
between fax and voice calls.
Receives documents
automatically and rings for
voice calls.
Rings for every call,
regardless of whether the
call is a fax call or a voice
call. For a fax call, you have
to manually activate
reception of the fax.
The fax rings differently
depending on whether a
call is a fax or voice call.
Answers all calls as fax calls.
Receives documents
automatically and
disconnects voice calls.
Requirements
Handset or extension
phone connected to the
fax.
Handset or extension
phone connected to the
fax.
Subscription to a DRPD
service. Handset or
extension phone
connected to the fax.
Separate telephone line for
fax use only.
If you want to be alerted
when a fax call is received,
connect the handset, or an
extension phone to the fax,
and enable the INCOMING
RING setting.
Details
User's Guide
p. 5-2
User's Guide
p. 5-4
User's Guide
p. 5-5
User's Guide
p. 7-4