6.10 Speaker
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the speaker cable from the system board.
5. Free the cable from the cable tie that is attached to the chassis.
6. Remove the screw that secures the speaker to the inside of the chassis 1 then, remove the
speaker 2 by sliding it out of the retaining clips
To install the speaker, reverse the removal procedure.
When installing the speaker, make sure the speaker wires point towards the speaker retaining
screw.
Service Reference Guide, dx2200 MT
Removal and Replacement Procedures— Microtower (MT) Chassis
(Section 6.1, "Preparation for
(Section 6.2, "Access
Panel").
(Section 6.3, "Front
Bezel").
415606-001
Disassembly").
6–19