Power Switch Assembly - HP dx2200 - Microtower PC Service & Reference Manual

Removal and Replacement Procedures— Microtower (MT) Chassis

6.9.1 Power Switch Assembly

1. Prepare the computer for disassembly
2. Remove the access panel and rotate the computer so the system board is parallel to the table
to make it easier to work on
3. Disconnect the braided Power/LED cables from the system board.
4. Free the braided cables from the cable tie that is attached to the chassis.
5. Squeeze the top of the switch holder 1. rotate the switch, and remove it from the chassis.
To install the power switch assembly, reverse the removal procedures.
6–18
(Section 6.1, "Preparation for
(Section 6.2, "Access Panel").
415606-001
Disassembly").
Service Reference Guide, dx2200 MT