Removing An Internal 3.5-Inch Hard Drive - Compaq dc5800 - Microtower PC Reference Manual

Removing an Internal 3.5-inch Hard Drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and
any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Disconnect the power cable (1) and data cable (2) from the back of the hard drive.
5. Release the drive by pulling the release tab away from the drive (1) and sliding the drive out of the
bay (2).
6. Remove the four guide screws (two on each side) from the old drive. You will need these screws
to install a new drive.
86 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page 67).
61).
66).