Compaq 195294-001 - ProLiant - ML370R Quick Install Manual page 17

NOTE: SCO UnixWare 7 (with Mirroring Option or Online Data Manager) and UnixWare 7
NonStop Clusters software licenses must be purchased through your SCO reseller or
distributor. To locate a convenient SCO reseller or distributor to purchase licenses, see the
SCO website at
http://www.sco.com
Quick Install CDs for the ProLiant ML370 Server
The Quick Install CDs for the ProLiant ML370 server provide rapid and
simplified cluster installation. These CDs contain all the necessary software
already configured for immediate cluster boot. An installation wizard allows
you to enter parameters and licenses specific to your configuration.
The Quick Install CDs for the ProLiant ML370 server contain a
file, which includes descriptions of potential problems and how to avoid or
correct them.
The Quick Install CDs for the ProLiant ML370 server also include the
following utilities:
I
NonStop Clusters Verification Utility (NSCVU)
The NSCVU validates Compaq ProLiant Clusters for SCO UnixWare 7
and their components. The NSCVU is run from any node in the cluster
and tests cluster configuration in the following categories:
G
ServerNet I connectivity tests verify that the nodes in the cluster can
communicate over X and Y ServerNet I paths.
G
Ethernet connectivity tests verify that the nodes can communicate
over the Ethernet cluster interconnect.
G
Storage tests verify the presence of, and minimum configuration
requirements of, supported HBAs, array controllers, and external
storage subsystems.
G
System software tests verify that SCO UnixWare 7 and SCO
UnixWare 7 NonStop Clusters software have been properly
installed.
For further information on running the NSCVU, refer to the
manual page, which can be viewed with the
SCOhelp online documentation set.
I
Uninterruptible Power Supply (UPS) software
This software provides management capabilities for UPSs connected to
the cluster.
Clustering Overview 1-7
readme.html
1M
nscvu(
1M command or in the
man( )
)