Compaq Proliant Clusters For Sco Unixware 7 U/300; Hardware Components - Compaq 195294-001 - ProLiant - ML370R Quick Install Manual

1-2 Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant ML370
Compaq ProLiant Clusters for SCO
UnixWare 7 U/300

Hardware Components

The Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install
Cluster Kit (U/300 kit) for the ProLiant ML370 server supports specific
hardware components, enabling the cluster software to be installed in about an
hour. Cluster components include servers, internal disk drives, external
storage, cluster interconnect, software, and local area network (LAN)
hardware. Cluster software provides installation capabilities, the operating
system, and various Compaq cluster management utilities. To set up the
cluster, you must assemble the cluster components, initialize them, and install
the cluster software.
Supported cluster hardware components for this Quick Install include ProLiant
ML370 servers, the Compaq StorageWorks RAID Array 4100 (RA4100)
storage subsystem, the hardware required for the cluster interconnect, public
network interface controller (NIC), and the Cluster Integrity (CI) serial cable.
Server Components
The U/300 kit for the ProLiant ML370 server supports the following server
hardware components:
I
Two identical ProLiant ML370 servers with an embedded NIC in each
server
I
One 9.1-GB or larger disk drive in each server
I
One 64-bit Fibre Channel Host Bus Adapter (HBA) in slot 3 of each
server
I
Two Gigabit Interface Converters Shortwave (GBIC-SW), one installed
into each HBA in slot 3 of each server
I
One CI serial cable (provided in the cluster kit)
I
For clusters using Ethernet interconnect:
G
One Compaq NC3123 Fast Ethernet NIC (NC3123 NIC) PCI 10/100
Wake on LAN (WOL) installed into slot 1 of each server for public
network access
G
One crossover cable for the cluster interconnect (provided in the
cluster kit)