Removing An Expansion Card; Riser Board - Dell PowerEdge HX574 Hardware Owner's Manual

Removing an Expansion Card

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 67.
3 Disconnect all cables from the card.
4 Remove the expansion card:
Open the expansion-card retainer. See Figure 3-11.
a
Grasp the expansion card by its edges, and carefully remove it from
b
the expansion-card connector.
5 If you are removing the card permanently, install a metal filler bracket over
the empty expansion slot opening and close the expansion-card retainer.
NOTE:
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
6 Close the system. See "Closing the System" on page 68.

Riser Board

Two riser boards are available for your system:
• A 2-processor (2P) riser board
• A 4-processor (4P) riser board
You must install a filler bracket over an empty expansion slot to
Installing System Components
83