Installing The Chassis Intrusion Switch - Dell PowerEdge HX574 Hardware Owner's Manual

Figure 3-28. Removing and Installing the Chassis Intrusion Switch
1 intrusion switch

Installing the Chassis Intrusion Switch

1 Connect the intrusion-switch cable to its system board connector. See
Figure 3-28.
2 Insert the switch into the opening in the chassis wall and gently, but firmly,
press in the switch until it is fully seated. See Figure 3-28.
3 Close the system. See "Closing the System" on page 68.
4 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1
2
2 intrusion switch cable
Installing System Components
123