Boot Settings Screen - Dell PowerEdge E07S Series Owner's Manual

Option
Port C
(Off default)
Port D
(Off default)
Port E
(Auto default)

Boot Settings Screen

Option
Boot Mode
(BIOS default)
Boot Sequence
Boot Sequence Retry
(Disabled default)
Description
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
Auto enables BIOS support for the device attached to
SATA port D. Off disables BIOS support for the device.
Auto enables BIOS support for the device attached to
SATA port E. Off disables BIOS support for the device.
Description
CAUTION:
the system from booting if the operating system was
not installed in the same boot mode.
If the operating system supports Unified Extensible
Firmware Interface, you can set this option to UEFI.
Setting this field to BIOS allows compatibility with non-
UEFI operating systems.
NOTE:
Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
If Boot Mode is set to BIOS, this field tells the system
where the operating system files needed for startup are
located. If Boot Mode is set to UEFI, you can access the
UEFI boot manager utility by rebooting the system and
pressing <F11> when prompted to do so.
If this field is enabled and the system has failed to boot,
the system will reattempt to boot after 30 seconds.
Using the System Setup Program and UEFI Boot Manager
Switching the boot mode could prevent
59