Lcd Status Messages (Optional) - Dell PowerEdge E07S Series Owner's Manual

LCD Status Messages (Optional)

The system's control panel LCD provides status messages to signify when the
system is operating correctly or when the system needs attention.
The LCD lights blue to indicate a normal operating condition, and lights
amber to indicate an error condition. The LCD scrolls a message that
includes a status code followed by descriptive text. The table that follows
provides a listing of LCD status messages and the probable cause for each
message. The LCD messages refer to events recorded in the System Event
Log (SEL). For information on the SEL and configuring system management
settings, see the systems management software documentation.
NOTE:
If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help" on page 169.
Table 1-2. LCD Status Messages (Optional)
Code Text
N/A
SYSTEM NAME
E1000 Failsafe
voltage error.
Contact
support.
Causes
A 62-character string that
can be defined by the user
in the System Setup
program.
The SYSTEM NAME is
displayed under the
following conditions:
• The system is
powered on.
• The power is off and
active errors are
displayed.
Check the system event
log for critical failure
events.
Corrective Actions
This message is for
information only.
You can change the
system ID and name in
the System Setup
program. See "Using the
System Setup Program
and UEFI Boot Manager"
on page 53.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 169.
About Your System
25