Dynex DX-WBRDVD1 User Manual page 48

48
Power
Problem
No power
The player switches to standby
mode
Operation
Problem
Remote control does not
work
Some or all functions do not
work
Playback fails to start or
starts then stops even when
(play) is pressed
Start up is slow and audio
and video output takes a
long time
When reading a disc, the
disc tray opens
Audio or video pause during
playback
Make sure that the power cord is plugged into a power outlet and that the outlet is
supplying power.
After a period of inactivity, your player switches to standby mode automatically. This
is a power saving feature.
If your player switches to standby mode unexpectedly, a safety device may have
been activated. Press
• Make sure that you are pointing the remote control at the remote control sensor on
the front of your player.
• Make sure that there are no obstructions between the remote control and the
remote control sensor on the front of your player.
• Make sure that there is no colored glass between the remote control and the remote
control sensor on the front of your player. Colored glass, such as the glass door of an
entertainment center, can interfere with signal reception.
• Make sure that the remote control sensor is not exposed to direct sunlight or bright
light. These can interfere with signal reception.
• If the batteries came wrapped in clear plastic, make sure the plastic has been
removed.
• Replace the batteries.
• Some functions are not allowed by the disc, for example, fast-forwarding through
the warning information at the beginning of the disc.
• Condensation may have formed inside your player. Turn off your player and wait one
to two hours for the condensation to evaporate.
• Reset your player. For instructions, see "Resetting your player" on page 47.
• Make sure that the disc is inserted face up in the disc tray.
• Make sure that the disc is not dirty. For instructions, see "Cleaning discs" on page 46.
• The disc may be blank or incompatible with your player. Try another disc.
• If power has been interrupted or the power cord has just been connected, startup is
slow. This is not a defect.
• If your player is connected to the TV with an HDMI cable, startup is slow. This is not a
defect.
• Make sure that the disc is not dirty. For instructions, see "Cleaning discs" on page 46.
• The disc may be incompatible with your player. Try another disc.
• Reset your player. For instructions, see "Resetting your player" on page 47.
• Make sure that the disc is not dirty. For instructions, see "Cleaning discs" on page 46.
• Reset your player. For instructions, see "Resetting your player" on page 47.
DX-WBRDVD1/DX-WBRDVD1-CA
Solution
STANDBY/ON on the front of your player.
Solution