Dynex DX-WBRDVD1 User Manual page 15

DX-WBRDVD1/DX-WBRDVD1-CA
6 Press or to select the wireless network you want your player to connect to, then
press ENTER. A Network Setup screen opens with the following options:
• Connect—Connect to this network.
• Disconnect—Disconnect from this network.
• Delete—Delete the current network.
• WPS Pin—Create a random PIN number password.
7 If your network does not use encryption, press or to select Connect, then press
ENTER. If the wireless network is working, you should see a checkmark and a
connected message on the TV. If the message does not appear, repeat the steps above.
8 Press to go to the previous menu.
If your network uses encryption:
1 Press or to select the Password field, then press ENTER. An on-screen keyboard
opens.
2 Press
this step to enter the rest of the password. If you make a mistake, use the Clear key to
delete the character.
3 After you enter the password, select the red Done in the upper left-hand corner of the
keyboard, then press ENTER to close the keyboard.
4 Press or to select Connect, then press ENTER. If the wireless network is working,
you should see a checkmark and a connected message on the TV. If the message does
not appear, repeat the steps above.
To connect to a wireless network using Wi-Fi Protected Setup (WPS), see "Setting up
WiFi protection (WPS)" on page 41.
5 Press to go to the previous menu.
Connecting using a wired network
Another connection option is to use a wired router as shown in the example below.
To connect to the ethernet with a wired network:
1 Connect a network cable to the INTERNET jack on the back of your player and into a
wired router using a commercially available LAN or Ethernet cable
(Cat 5 or better, with RJ45 connectors).
or to select the first letter in the password, then press ENTER. Repeat
Network cable
Wired router
Back of player
15