Dynex DX-WBRDVD1 User Manual page 16

16
Using a wired network provides the best performance, because the attached devices
connect directly to the network and are not subject to radio frequency interference.
Notes:
• When plugging or unplugging the LAN cable, hold the plug portion of the cable. When
• Do not connect a modular phone cable to the LAN port.
• Since there are various connection configurations, follow the specifications of your
2 Press ENTER. The Settings menu opens.
3 Press or to select Network.
4 If the network connection is active, Link Up appears next to Link Status. If the
network connection is not active, Link Down appears next to Link Status. Press
ENTER.
5 Select IP Mode, then press ENTER.
6 Press or to select an IP mode. You can select:
• Dynamic—Uses DHCP to automatically obtain an IP address.
• Manual—Lets you manually configure network settings, such as IP address,
subnet mask, and gateway settings. If you select Manual, the following screen
opens. Enter the IP information here.
7 Press to go to the previous menu.
To make changes to your network connection, see "Changing the Network settings" on
page 39.
unplugging, do not pull on the LAN cable but unplug while pressing down on the lock.
telecommunication carrier or Internet service provider.
Language
Parental
System
Settings
Network
BD-Live
Display
Audio
Please enter new IP Address
Valid range of each segment is 0 to 255
Current value
New Value
OK
DX-WBRDVD1/DX-WBRDVD1-CA
Network
Wired
Interface
Link Status Link Up
MAC Address 00:22:84:FB:C6:05
IP Mode Dynamic
IP Address 192.168.42.119
Subnet Mask 255.255.255.0
Gateway 192.168.42.1
Primary DNS 202.96.128.166
Secondary DNS 10.4.4.11
111.11.11.11
Canc el