Dynex DX-WBRDVD1 User Manual page 41

DX-WBRDVD1/DX-WBRDVD1-CA
6 If your network does not use encryption, press or to select Connect, then press
ENTER. If the wireless network is working, you should see a checkmark and a
connected message on the TV. If the message does not appear, repeat the steps above.
OR
If your network uses encryption:
1 Press or to select the Password field, then press ENTER. An on-screen keyboard
opens.
2 Press
this step to enter the rest of the password. If you make a mistake, use the Clear key to
delete the character.
3 After you enter the password, select the red Done in the upper left-hand corner of the
keyboard, then press ENTER to close the keyboard.
4 Press or to select Connect, then press ENTER. If the wireless network is working,
you should see a checkmark and a connected message on the TV. If the message does
not appear, repeat the steps above.
Setting up WiFi protection (WPS)
To set up WiFi protection (WPS):
1 Press ENTER. The Settings menu opens.
2 Press or to select Network.
3 Press , then press to select WiFi Protected Setup (WPS), then press ENTER. A
screen appears, asking you to press the button on your router.
4 Press the button on top of your router. A screen should appear on your TV that says
"Success" when your player is connected to the router. Press ENTER to close the
message.
5 Press to go to the previous menu.
Manually setting access point entry
To configure the wireless Internet connection:
1 Press ENTER. The Settings menu opens.
or to select the first letter in the password, then press ENTER. Repeat
Language
Parental
Interface
Link Status
MAC Address
System
IP Mode
IP Address
Settings
Network
Subnet Mask
Gateway
Primary DNS
BD-Live
Secondary DNS
Signal Strength
Display
Network Name(SSID)
Audio
WIFI Protected Setup (WPS)
Please press the button on your router now
Cancel
Network
Wireless
Link Up
00:26:4D:B4:01:54
Dynamic
192.168.42.131
255.255.255.0
192.168.42.1
202.96.128.166
10.4.4.11
Excellent
TP-Link
41