Table of Contents
Advertisement
Cyclonic vac VC71050M Rev 2
Dust disposal
To obtain the best results from your
cleaner empty the dust container regularly,
otherwise the airflow and cleaning power
will be reduced.
1 Remove the dust container from the
product by pressing the dust container
release button fl and pulling the dust
container away from the product. D
2 Holding the dust container over a
dustbin press the dust release button as
shown E, the bottom of the dust
container will drop down to release the
dirt.
3 Close the bottom of the dust container
by pressing the base upwards until it
clicks into place.
4 Push the dust container back onto the
product to refit.
19/6/03
5.02 PM
Page 6
Cleaning the motor
protection filter
1 Remove the dust container from the
product by pressing the dust container
release button fl and pulling the
container away from the product. After
emptying any dirt into the dustbin as
detailed in E.
2 Remove the motor protection filter ‡
from the top of the dust container by
pushing the filter release switch to
release the filter and lift the filter out of
the container from the top.F. The filter
can be gently knocked against the side
of the dustbin to remove excess dust.
Use the filter cleaning brush È to
remove dirt from between the pleats.
3 To re-fit the filter, drop the cartridge into
the hole in the top of the dust container.
Ensure the top of the filter is located
under the lug and push the filter release
switch to allow the filter to drop into
place. The filter release switch will then
automatically flick back when released to
lock the filter in place.
D
The filter should be regularly washed in
cold water and left to air dry before
inserting back into the machine.
IMPORTANT: Do not use detergents to
clean the filter. The filter must be thoroughly
dry before the machine is used.
A spare filter is provided.
IMPORTANT: The dust container will not
lock back onto the machine unless the filter
is fitted correctly
E
Filter
release
switch
5
F
locating
lug
Advertisement
Table of Contents
