Quick Start - Morphy Richards IB71050 Instructions Manual

Cyclonic vac VC71050M Rev 2

Quick start

1 Assemble the nozzle, telescopic tube
and hose as shown A.
2 Pull out the mains cable to it's full length
and plug into the mains supply.
3 Switch on by pressing the foot pedal ›.
Accessories
1 Fit the hose to the cleaner by inserting
the hose end into the hose inlet ⁄.
When removing, squeeze the clips either
side and pull.
2 Attach the telescopic tube to the handle
end of the hose. Extend to the required
length by pressing down the slider
release and pulling out the tube B.
The hose handle features an airflow
regulator  which allows suction to be
reduced as required.
3 Attach the wheeled floor nozzle Ì to the
tube.
The crevice tool Í (for awkward places,
behind radiators etc) and the upholstery
nozzle Î with clip on brush Ï (for curtains
and upholstery) are stored in the tool
drawer ‚. The crevice tool is used for hard
surfaces, pelmets, delicate objects etc C.
Stair cleaning hose
An additional stretch hose is also
provided for use on stairs. Fit the hose to
19/6/03 5.02 PM
Ó
B
4
Page 5
the cleaner by inserting the hose end into
the hose inlet. When removing squeeze the
clips either side and pull.
WARNING: For safety, always leave
the cleaner at the bottom of the stairs
and clean upwards.
Controls
Power
The on/off control is operated by the foot
pedal ›.
Variable power
A sliding switch fi varies the suction
power as required. For example, maximum
suction can be used for cleaning carpets,
hard floors etc. and reduced suction for
cleaning upholstery and curtains.
Suction can also be controlled using the
airflow regulator on the handle Â. Closed
for maximum suction, open for reduced
suction.
Automatic cable rewind
After use, unplug and press the cable
rewind button ¤ to retract the cable.
WARNING: When using the cable
rewind, always hold the plug as the cable
will rewind quickly.
Í
Î
C
Ï