Changing The Dust Bag - Morphy Richards Storm Manual

70318 rev2 21/1/08
F
G
H
I
J
K
L
M
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
6
14:40 Page 6
Tube standby
During short breaks in cleaning,
the tubes can be held in an
upright, 'standby' position ‡,
whilst you move furniture for
instance.
IMPORTANT: Ensure that the
appliance is never left
unattended whilst it is switched
on.
Switching off
G
Switch off the appliance.
Remove the plug from the
mains supply and rewind the
power cable using the cable
rewind switch fl.
WARNING: When using the
cable rewind, always hold
the plug as the cable will
rewind quickly.
STORAGE
Tube park
H
The vacuum cleaner can be
stored in an upright position.
Rotate the floor nozzle until the
lug on the neck can be fitted
into the tube park slot on the
base of the appliance ·.
DUSTBAG
Changing the
dustbag
If suction power is reduced or if
the 'dust bag full' indicator ‹ is
permanently fully red, the dust
bag needs changing. Also,
check whether the suction
hose, tube or nozzle are
blocked.
To access the dust bag, press
the dust compartment release
lever „ to open the cover I.
1 Pull the tab on the dust bag to
one side so that the opening is
hygienically sealed.
2 Pull out the dust bag holder and
dust bag in an upward direction
J.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5
F
3 Pull the bag sideways out of the
holder K.
4 Dispose of the bag with your
household waste.
5 Insert a new dust bag in the
holder.
6 Replace the dust bag holder
and close the cover.
IMPORTANT: The dust bag
compartment cover can only be
closed once a dust bag has
been correctly fitted.
FILTERS
Changing/cleaning
the motor protection
filter
The motor protection is
accessible from the dust
compartment only when the
dust bag has been removed
first.
IMPORTANT: Never use the
appliance without the motor
protection filter installed,
otherwise damage to the motor
may occur which would not be
covered by the guarantee.
1 Slide the filter upwards to
remove L.
2 Open the flap on the filter
holder.
Take out the filter and clean (by
3
shaking) or wash M.
4 To wash the filter, gently wash in
warm water and leave to air dry.
Do not use detergents. Ensure
the filter is fully dry before
replacing into the machine.
5 Close the filter holder and place
back into position before
removing.
It is recommended that this filter
is cleaned everytime the
dustbag is changed, and
replaced every 5 dustbag
changes.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9