Operating The Appliance - Morphy Richards CYCLONIC BAGLESS UPRIGHT VACUUM CLEANER Instructions Manual

73337 rev1 29/10/08
A
B
C
⁄
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
4 4
16:05 Page 4
OPERATING THE
APPLIANCE
Assembly
A
WARNING: Do not plug in the
cleaner until it is assembled.
1 Carefully unpack all of the
components.
2 Lift the cleaner body to the
upright position.
Remove the two screws that are
3
already attached to the body.
4 From the rear of the cleaner, align
the handle with the groove and
slide into the body. If necessary,
use thumb and finger pressure to
slide the handle into position.
5 Fasten the handle with the two
screws.
Floor nozzle
height adjustment
fi
Before using the cleaner, the floor
nozzle height fi must be set to
the correct height.
Choose the setting which most
closely matches your floor
surface.
• Use the TOOLS setting when
using the tools.
Note: The height adjustment only
comes into effect when the
handle is released by the handle
release pedal Í.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5
Eco Switch
The Eco Switch ⁄ allows you to
turn down the power when
cleaning more delicate items,
such as curtains and upholstery,
saving energy and reducing costs.
Using on carpets
Place the cleaner in it's upright
1
position.
2 Set the carpet height adjustment
knob fi to the desired position.
3 Release the mains cable by
revolving the quick release cleat
‚ half-a-turn and extend the
cable fully.
4 Plug the cable into the mains
socket.
5 Step on the handle release pedal
Í to release the handle to the
desired position.
6 Press the on/off switch „ to the
'on' position.
B
IMPORTANT: To prevent damage
to carpets, never leave the cleaner
switched on in one place for an
extended period.
• Never have the brushes set too
low such that the cleaner is hard
to push.
Using the
attachments
Follow steps 1-4 but set the
carpet height adjustment knob to
the TOOLS setting.
5 Remove the hose connector Î
from the rear of the cleaner. Lift
the hose · from the top handle
hook. Insert the hose clip Ë into
the hose clip slot È.
• Push the required attachment
firmly onto the end of the hose.
• If additional length is required,
attach one or both extension
tubes Â.
6 Switch on „.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9
C