Advertisement
73332 rev1
17/10/07
A
B
4 4
F F o o r r A A d d v v i i c c e e , , S S p p a a r r e e s s o o r r A A c c c c e e s s s s o o r r i i e e s s , , t t e e l l : :
10:40
Page 4
OPERATING THE
APPLIANCE
Assembly
A
WARNING: Do not plug in
the cleaner until it is
assembled.
Carefully unpack all of the
1
components.
2
Lift the cleaner body to the
upright position.
3
Remove the two screws that are
already attached to the body.
4
From the rear of the cleaner,
align the handle with the groove
and slide into the body. If
necessary, use thumb and finger
pressure to slide the handle into
position.
5
Fasten the handle with the two
screws.
Floor nozzle
height adjustment
Before using the cleaner, the
floor nozzle height must be set
to the correct height.
Choose the setting which most
closely matches your floor
surface.
•
Use the TOOLS setting when
using the tools.
Note: The height adjustment
only comes into effect when the
handle is released by the handle
release pedal È.
0 0 8 8 4 4 5 5 0 0 7 7 7 7 7 7 7 7 0 0 0 0 ( ( U U K K ) )
Eco Switch
(Certain models only)
The Eco Switch ⁄ allows you
to turn down the power when
cleaning more delicate items,
such as curtains and upholstery,
saving energy and reducing
costs.
C
Using on carpets
1
Place the cleaner in it's upright
position.
2
Set the carpet height
adjustment knob to the desired
position.
3
Release the mains cable by
revolving the quick release cleat
half-a-turn and extend the cable
fully.
B
4
Plug the cable into the mains
socket.
5
Step on the handle release
pedal to release the handle to
the desired position.
6
Press the on/off button to the
'on' position.
IMPORTANT: To prevent damage
to carpets, never leave the
cleaner switched on in one
place for an extended period.
•
Never have the brushes set too
low such that the cleaner is hard
to push.
o o r r
1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9 ( ( I I r r e e l l a a n n d d ) )
C
Advertisement
