Operating The Appliance - Morphy Richards VC73240MUK Instruction Booklet

VC73240MUK Rev1_Instruction Booklet 09/02/2011 16:39 Page 3

OPERATING THE APPLIANCE

1 Fit the hose to the cleaner by inserting the
hose connector Ì into the hose inlet fi and
turning it anti-clockwise until it locks into
place A.
A
To remove, turn clockwise.
Attach the metal telescopic tube Á to the
2
hose handle Ó.
Extend the telescopic tube to the required
length by pressing down the tube release
button Ë and pulling out the tube B.
B
Attach the combination floor nozzle Î to the
3
telescopic tube C.
C
Use the brush height adjustment switch Ï
to switch between two positions:
• Brush up for carpets, rugs etc.
• Brush down for hard floors, tiles etc.
Pull out the power cable ‰ to its full length
4
and plug in to the mains supply. A yellow
mark on the power cable indicates the
recommended cable length. Do not pull out the
cable beyond the red mark.
For details of other Morphy Richards products, please see our website:
Switch on by pressing the On/Off button ‚.
5
To switch off, press the On/Off button again.
6 After use, unplug and press the automatic
cable rewind button · to retract the power
cable.
WARNING: When using the automatic
cable rewind button, always hold the plug
as the power cable will rewind quickly.
Using & cleaning the turbo
nozzle
(certain models only)
When vacuuming pet hair, stairs and
upholstery, attach the turbo nozzle Ú to either
the hose handle Ó or the telescopic tube Á
as described in 'Operating the appliance'.
IMPORTANT: Do not use the turbo nozzle on
suede and leather surfaces.
Following use, hair or fibres may become
wrapped around the brush bar, reducing the
performance. To remove:
1 Switch the vacuum cleaner off and disconnect
the power plug ‰ from the electrical outlet.
2 Lay the turbo nozzle on a flat surface and turn
over to expose the brush bar.
3 Using a pair of scissors, carefully cut through
any threads or hairs wrapped around the brush
bar D.
D
If large particles are picked up, they may
become trapped in the turbo fan and stall the
brush bar. Open the fan cover to remove the
trapped item.
Fan cover
3