Advertisement
73370 rev5
19/12/06
Assembly
WARNING: Do not plug in
the cleaner until it is
assembled.
1
Carefully unpack all
components.
2
Lift cleaner body to upright
position.
3
Insert the handle, with the 'D'
shape facing forward into the
hole on the top of the product.
Push down until it clicks.
NOTE: The handle may be
removed by lifting while
simultaneously pushing the
release button with a suitable
tool eg. a small screwdriver.
A.The release button is located
in a hole at the rear of the
product just above the cable
cleat. Rotate the cable cleat
downwards for easier access.
Adjustable handle
1
The handle height can be
adjusted to suit different height
users or pushed fully down for
easier carrying and storage.
2
Pull the adjustable height trigger
‰ upwards whilst pulling the
handle upwards or pushing the
handle downwards depending
on the desired height.
3
For carrying and storage pull
adjustable height trigger
upwards and push handle fully
down until it clicks into place.
OPERATING THE
APPLIANCE
Using on carpets
1
Place cleaner in its upright
position.
2
Release the mains cable by
turning the quick release cleat
Á half a turn and extend the
cable fully.
3
Plug the mains cable into the
mains socket.
4
Adjust the handle to the required
height.
4
UK Helpline 0870 060 26
13:09
Page 4
5
Clip the cable into the cable clip
holder Ò at the rear of the
handle.
6
Place your foot on the foot pad
· on the floorhead whilst
pulling the handle towards you
to release the handle into the
cleaning position C.
7
Press the power on/off switch
¤ D on the floorhead for the
main power. Then press the
brush-bar on/off switch ‹ to
activate the brush-bar motor for
carpet cleaning.
IMPORTANT: To prevent
damage to carpets, never
leave the cleaner switched
on in one place for an
extended period.
IMPORTANT: The rotating
brush bar will automatically
stop when the cleaner is
put into the upright
position.
B
Using on hard floors
Follow steps 1-6 from the
instructions for 'Using on
carpets.'
Press the brush bar on/off pedal
‹ to turn the brush bar off.
Using the hose and
attachments
Take the flexible hose Ê out of
1
the storage holder.
2
Pull down the hose connector
inlet flap È and insert the hose
connector with its 'mouth'
pointing upwards E. Push the
hose connector fully in such that
the flap latches on to the
connector.
3
Add the required accessory
directly to the tube connector Í
or fit the extension tubes for
maximum reach.
4
When removing the connector,
gently lower the flap slightly to
release the catch then withdraw
the connector.
IMPORTANT: With the hose
connector fitted all of the
Replacement Parts 0870 167 6635
‰
‹
Â
Ë
È
Ireland Helpline 1800 409119
A
B
C
·
D
¤
E
Advertisement
