Table of Contents
Advertisement
Quick Links
VC73360MUK-CyclonicBaglessRev3
3/11/05
Cyclonic bagless vacuum cleaner
Please read and keep these
instructions
getting the best from
your new cleaner...
If your cleaner isn't picking up as well as it should,
please check
• Dust canister
It is important to regularly empty the canister even if it does not
appear full.
• Filters
It is important that the pleated filter is shaken clean each time
the dust canister is emptied to allow air through the appliance.
Wash the canister filters regularly in warm water and allow to
air dry. A spare pleated filter is included.
• Blockages
Check the hose, tubes and tools for blockages
• Belt
Check and replace damaged or broken belt
• Height adjustment
The height adjustment only comes into effect when the handle is
released by the handle release pedal
4:41 pm
Page 1
È
.
www.morphyrichards.com
Advertisement
Table of Contents
Related Manuals for Morphy Richards Bagless Vacuum Cleaner
Summary of Contents for Morphy Richards Bagless Vacuum Cleaner
- Page 1 VC73360MUK-CyclonicBaglessRev3 Cyclonic bagless vacuum cleaner getting the best from your new cleaner... If your cleaner isn’t picking up as well as it should, please check • Dust canister It is important to regularly empty the canister even if it does not appear full.
-
Page 2: Important Safety Instructions
• Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. • Use only genuine Morphy Richards spare parts and accessories • Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. - Page 3 VC73360MUK-CyclonicBaglessRev3 ⁄ ¤ ‹ › fi fl Accessories included Furniture brush Á Features ⁄ Vari power slider (certain models only) ¤ Front cover release ‹ Removable front cover › Exhaust filter grille fi Carpet height adjustment knob fl Floor nozzle with powered brush ‡...
-
Page 4: Using Attachments
VC73360MUK-CyclonicBaglessRev3 Assembly WARNING: Do not plug in the cleaner until it is assembled. 1 Carefully unpack all components. 2 Lift cleaner body to upright position. 3 Remove the two screws that are already attached to the body. 4 From the rear of the cleaner, align the handle with groove and slide into the body. - Page 5 VC73360MUK-CyclonicBaglessRev3 and tools. • Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. Using & cleaning turbo nozzle (Certain models only) Attach the turbo nozzle to the hose end connector Í...
-
Page 6: Safety Cut-Out
If the brush bar stops rotating it is likely that the drive belt has snapped (usually because the brush has been stalled). A spare belt is supplied. Replacement belts can also be obtained from Morphy Richards. Accessing the floor nozzle 1 Disconnect the cleaner from the mains supply. - Page 7 VC73360MUK-CyclonicBaglessRev3 5 Using a flat bladed screwdriver or a coin, rotate the three cover fixings, a quarter of a turn, from lock to unlock J. 6 Lift the base cover, from the rear fixing area first, the cover will rotate forward. Unhook cover from front edge and remove N.
- Page 8 4 Where the appliance has been used for hire purposes or non-domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Consumables such as the filters and belt are not covered by the guarantee.