Summary of Contents for Morphy Richards BIG POD BAGLESS VACUUM CLEANER - REV 2
Page 1
A spare pleated filter is provided. • Blockages Check the tools and hose for blockages. For replacement parts, help with using your Morphy Richards products and lots more, contact us by phone or through our website www.morphyrichards.com Helpline: 0870060 2615...
WARNING: Danger of personal injury Unprofessional repairs can be dangerous IMPORTANT: Damage to the appliance for users. In addition we offer the following • Use only genuine Morphy Richards spare essential safety advice. parts and accessories. Location Electrical • Do not use or keep this product outside requirements when it is raining.
Page 3
73195 rev2 24/10/05 11:55 AM Page 3 Features ⁄ Pod release latch Accessories you should have ¤ Cable rewind button  Floor nozzle ‹ Handle Ê Hose/handle with airflow control › Power on/off switch Á Upholstery nozzle fi Wheels Ë Telescopic metal tube fl...
Page 4
73195 rev2 24/10/05 11:55 AM Page 4 Assembly Controls IMPORTANT: Switch off before fitting or On/off control removing accessories. Fitting the flexible hose Press the on/off switch › to start the Insert the flexible hose connector · in machine, press again to turn off. the hose inlet duct ‡...
73195 rev2 24/10/05 11:55 AM Page 5 inside the mesh filter to shake After use loose the dust. E 11 Lift out the pleated filter Ï then empty out the dust from the mesh filter Î into 1 Switch off the vacuum cleaner. the bin E 2 Unplug from the mains.
Page 6
73195 rev2 24/10/05 11:55 AM Page 6 If there is resistance when you re-fit the pod onto the cleaner, remove and carefully reseat the filter assembly back into the pod, ensuring the filter assembly seal is located fully and neatly. Washing the pleated filter For total cleaning of the pleated filter it...
73195 rev2 24/10/05 11:55 AM Page 7 To clean the motor protection Motor protection filter filter 1 Remove the filter from the filter grille J. 2 Rinse the filter in luke warm water and This cleaner is fitted with a motor Dry the filter completely.
73195 rev2 24/10/05 11:55 AM Page 8 Exhaust filter Care and maintenance This filter should be replaced every 12 months or sooner if required. Remove the exhaust filter grille by pulling Your cleaner is manufactured to withstand the locking tabs towards you L. Remove the normal day-to-day use, but an occasional used filter.
Page 9
These numbers can be filters must be cleaned regularly and replaced if found on the base of the product. damaged. Morphy richards shall not be liable to replace Model no. Serial no. or repair the goods under the terms of the...