After Use - Morphy Richards BIG POD BAGLESS VACUUM CLEANER - REV 2 Instructions Manual

73195 rev2 24/10/05

After use

1 Switch off the vacuum cleaner.
2 Unplug from the mains.
3 Rewind the cable by pressing the rewind
button ¤.
WARNING: When using the cable
rewind, always hold the plug as the
cable will rewind quickly.
Emptying the pod
WARNING: Never operate the
cleaner without the dust pod filter
assembly Ï or motor protection filter
fitted.
1 Disconnect the cleaner from the mains
socket.
2 Disconnect the hose from the cleaner.
3 Remove the dust pod fl from the
cleaner by pushing the release latch
⁄D.
4 Take the dust pod to the bin.
5 Raise the filter assembly Í handle then
lift out the filter assembly from the dust
pod flE.
6 Empty the dust pod into the bin.
7 Place dust pod safely to one side.
8 Use the small brush Ì provided
(located on filter assembly) to remove
any fluff from the outside of the mesh
filter G.
9 Rotate the mesh filter Î clockwise to
release the mesh filter and pleated filter
Ï assembly from the filter holder G.
10 Rotate and flick the pleated filter
D
11:55 AM Page 5
inside the mesh filter to shake
loose the dust. E
11 Lift out the pleated filter Ï then empty
out the dust from the mesh filter Î into
the bin E
12Re-assemble filter assembly by placing
the pleated filter inside the mesh filter
then place the filter holder on top in the
correct position. Rotate the mesh filter
assembly anti-clockwise to lock the
assembly together H.
13 Place the filter assembly back inside the
dust pod making sure the filter assembly
is placed level and that the filter holder
seal is seated neatly.
14 Re-attach the dust pod to the cleaner by
hooking the bottom of the dust pod in
first, then closing the pod until it clicks
and the pod release catch ⁄. is fully
down and secured I.
E
F
5