After Use - Morphy Richards ESSENTIALS BAGLESS VACUUM CLEANER - REV 1 Manual

73206 rev1 29/10/07

AFTER USE

1 Switch off the vacuum cleaner.
2 Unplug from the mains.
3 Rewind the cable by pressing
the rewind button ‹.
WARNING: When using the
cable rewind, always hold
the plug as the cable will
rewind quickly.
EMPTYING THE
DUST CANINSTER
WARNING: Never operate
the cleaner without the
dust canister filter Î or
motor protection filter Ô
fitted.
1 Disconnect the cleaner from the
mains socket.
2 Disconnect the hose from the
cleaner.
3 Remove the dust canister ‡
from the cleaner by pushing the
release latch ⁄ C.
4 Take the dust canister to the
bin.
5 Rotate the pleated filter
inside the mesh filter to
shake loose the dust D.
6 Raise the filter assembly Î
handle then lift out the filter
assembly from the dust pod
‡E.
7 Empty the dust canister into the
bin.
8 Place dust canister safely to one
side.
13:22 Page 5
Cleaning the pleated
filter
You should clean the pleated
filter each time the product is
emptied.
1 Use the small brush Ó provided
(located on filter assembly) to
remove any fluff from the
outside of the mesh filter F.
2 Rotate the mesh filter Ì
clockwise to release the mesh
filter and pleated filter Ï
assembly from the filter holder
G.
3 Lift out the pleated filter Ï then
empty out the dust from the
mesh filter Ì into the bin.
4 Re-assemble the filter assembly
by placing the pleated filter
inside the mesh filter, then place
the filter holder on top in the
correct position. Rotate the
mesh filter assembly
anti-clockwise to lock the
assembly together H.
5 Place the filter assembly back
inside the dust canister. Make
sure the filter assembly is
placed level and that the filter
holder seal is seated neatly.
6 Re-attach the dust pod to the
cleaner by hooking the bottom
of the dust canister in first, then
close the canister until it clicks
and the canister release catch
⁄ is fully down and secured I.
If there is resistance when
you re-fit the canister onto
the cleaner, remove and
carefully reseat the filter
assembly back into the
canister, ensuring the filter
assembly seal is located
fully and neatly.
G
C
D
E
F
H I
5 5