Summary of Contents for Morphy Richards Boxer wet & dry vacuum cleaner
Page 1
Boxer wet & dry vacuum cleaner with blower function Please read and keep these instructions getting the best from your new cleaner... If your cleaner is not picking up as well as it should, please check • Filters It is important that the filter is cleaned regularly to allow air through the appliance.
• The appliance must never be left running when unsupervised. • This vacuum cleaner is intended for domestic use only. Misuse or use for commercial or any other purpose will render the guarantee invalid.
Page 3
Illustration ‹ ¤ ⁄ Ê Á Ë Features ⁄ Tank ¤ Upper body ‹ On/off switch › Tank latch fi Castors x 4 fl Carrying handle ‡ Inlet · Blower outlet (not shown) „ fl  › ‚ fi Í È...
Page 4
Assembly 1 Release the tank latches › and lift off the upper body ¤ 2 Remove any components stored inside the tank, please see page 3 for the list of accessories you should have. 3 Turn the tank upside down. 4 Press the castors fi...
• To fit the Foam filter 1 Remove cartridge filter. 2 Slide foam filter fully down over the float cage, located underneath the upper body. E 3 Inspect your filter regularly. To clean the filter, remove it from the float cage. If required rinse the filter in cold, water.
Emptying tank/replacing paper bag 1 Switch the unit OFF and disconnect from the mains. 2 Release the tank latches B and lift off the upper body. 3 Option 1 No bag fitted, empty rinse and dry the tank. Option 2 Bag fitted, remove the full bag and replace it with a new bag G.
Trouble shooting guide If a problem occurs always switch the unit off immediately. 1 Motor does not operate. • Check the unit is plugged in and switched • Check the fuse in the plug. • If using extension lead check the fuse in the extension lead.
Page 8
Your two year guarantee It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product.