Front-Wheel Stand - BMW R 1200 R Rider's Manual

silencer and tighten the screw
8
to the specified torque.
Clamp to silencer and
108
manifold
55 Nm
z
If the gap between the rear
wheel and the silencer is
too small, the rear wheel can
overheat.
The gap between the rear wheel
and the silencer must be at least
15 mm.
Tighten screw 2 for the brack-
et of the silencer in the rear
footrest to the specified torque.
Silencer to rear frame
19 Nm
OE
without centre stand
Remove the auxiliary stand.

Front-wheel stand

Install the front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support motorcycles not fitted
with a centre stand or without
other auxiliary stands. A motor-
cycle resting only on the front
wheel stand and the rear wheel
can topple.
Place the motorcycle on its
centre stand or another auxiliary
stand before lifting the front
wheel with the BMW Motorrad

front-wheel stand.

Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Install the rear-wheel stand
( 110).
with centre stand OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand with tool num-
ber (0 402 241) in combina-
tion with front-wheel adapter
(0 402 242).