Network Problems; Expresscard Problems; Power Problems - Dell XPS 140M Owner's Manual

• Ensure that you are following the memory installation guidelines (see "Memory" on page 112).
• Run the Dell Diagnostics (see page 77).

Network Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
C
H E C K T H E N E T W O R K C A B L E C O N N E C T O R
both the network connector on the back of the computer and the network jack.
C
H E C K T H E N E T W O R K L I G H T S O N T H E N E T W O R K C O N N E C T O R
communication exists. Replace the network cable.
R
E S T A R T T H E C O M P U T E R A N D L O G O N T O T H E N E T W O R K A G A I N
C
H E C K Y O U R N E T W O R K S E T T I N G S
your network to verify that your network settings are correct and that the network is functioning.

ExpressCard Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
C E C
H E C K T H E X P R E S S A R D
E
N S U R E T H A T T H E C A R D I S R E C O G N I Z E D B Y
Hardware icon in the Windows taskbar. Ensure that the card is listed.
I
F Y O U H A V E P R O B L E M S W I T H A
Dell" on page 145.
I
F Y O U H A V E P R O B L E M S W I T H A N
ExpressCard manufacturer.

Power Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide
C
H E C K T H E P O W E R L I G H T
power light is blinking, the computer is in standby mode—press the power button to exit standby
mode. If the light is off, press the power button to turn on the computer.
NOTE:
For information on standby mode, see "Power Management Modes" on page 41.
C —
H A R G E T H E B A T T E R Y
1 Reinstall the battery.
2 Use the AC adapter to connect the computer to an electrical outlet.
3 Turn on the computer.
.
Ensure that the network cable is firmly inserted into
—
Contact your network administrator or the person who set up
—
.
Ensure that the ExpressCard is properly inserted into the connector.
—
W
I N D O W S
D - E
E L L P R O V I D E D
E C
X P R E S S A R D N O T P R O V I D E D B Y
.
When the power light is lit or blinking, the computer has power. If the
—
The battery charge may be depleted.
No light indicates that no network
—
Double-click the Safely Remove
—
Contact Dell. See "Contacting
C —
X P R E S S A R D
D —
E L L
Contact the
Solving Problems
91