NEC POWERMATE PROFESSIONAL 9000 Service Manual page 199

5. Remove the slot cover. Save it to use over the slot in case the connector kit is
removed.
CAUTION: Take care not to drop the slot
cover or the slot cover screw into the system.
Hold the connector by its bracket. Insert it into the expansion slot.
6.
Use the slot cover screw removed earlier to secure the connector kit.
7.
8. Connect one end of the internal SCSI cable to the internal connector on the
connector kit.
9. Reconnect cables that were disconnected to free a path to the expansion slot.
Replace the drive cage (see "Replacing the Drive Cage").
10.
Replace the cover on the system unit (see "Replacing the Covers").
11.
The connector kit does not need to be terminated.
Figure 3-37 Removing a Slot Cover
Option Installation 3-43