SMC Networks HPAV-ETH Manual page 23

Power Consumption
Certification
LEDs
Power LED
(Red)
Link LED
(Green/Orange/Red)
Ethernet LED
(Green)
*1: The Power LED indicator will blink in standby mode. It will get into standby mode, if you plug the
device to outlet and no Ethernet link detected after booted and 60 second later. If you unplug the Ethernet
cable, it will get into standby mode after 60 seconds. Under standby mode, Link LED and Ethernet LED
will both be off.
4W Max (Normal mode)
Below 2W (Standby mode)
CE / FCC
On: Power on
Blinking: Standby mode (*1)
Off: Power off
On: Powerline Link detected and no traffic
Blinking: Powerline traffic detected
Green: The Powerline connection quality is good
Orange: The Powerline connection quality is fair
Red: The Powerline connection quality is bad
Off: No Powerline Link detected
On: Ethernet Link detected
Blinking: Ethernet traffic detected
Off: No Ethernet Link detected
22