Queue Cos-Map - SMC Networks 8624T - annexe 1 Management Manual

C L
OMMAND INE
Related Commands
show queue bandwith

queue cos-map

Use this command to assign class of service (CoS) values to the CoS
priority queues. Use the no form set the CoS map to the default values.
Syntax
queue cos-map queue_id [cos1 ... cosn]
no queue cos-map
• queue_id - The queue id of the CoS priority queue.
- Ranges are 0 to 3, where 3 is the highest CoS priority queue.
• cos1 .. cosn - The CoS values that are mapped to the queue id. It is a
space-separated list of numbers. The CoS value is a number from 0
to 7, where 7 is the highest priority.
Default Setting
This switch supports Class of Service by using four priority queues,
with Weighted Round Robin for each port. Eight separate traffic classes
are defined in IEEE 802.1p. The default priority levels are assigned
according to recommendations in the IEEE 802.1p standard as shown
in the following table.
3-124
I
NTERFACE
1
1
2
Queue
2 3
0
3
4
5
4
6
7