Table of Contents
Advertisement
ADSL Settings
Select your Country and Internet Service Provider. This will automatically
configure the Barricade with the correct Protocol, Encapsulation and
VPI/VCI settings for your ISP.
If your ISP uses Protocols PPPoA or PPPoE you will need to enter the
username and password supplied by your ISP.
If your ISP uses Protocol RFC1483 Routed you will need to enter the IP
address, Subnet Mask, and Default Gateway supplied by your ISP.
If your Country or Internet Service Provider is not listed in this screen,
you will need to manually enter settings. Go to "Parameter Setting -
Country or ISP Not Listed" on page 4-7 in the manual.
Note: If your ISP has not provided you with a DNS address and the
protocol is PPPoA, PPPoE or 1483 Bridging, you can leave this
field blank. The Barricade will then automatically obtain the DNS
address.
Click NEXT to continue.
C
ONFIGURING THE
4-6
B
ARRICADE
Advertisement
Table of Contents
