A
T
BOUT THE
IGER
Status LEDs
The LEDs, which are located on the front panel for easy viewing, are
shown below and described in the following table.
Figure 1-4. Port and System LEDs
LED
Power
RPU
Mgmt
MT-RJ Ports
Link
Act*
FDX*
FC*
* Use the Mode Select button to select the LED display mode.
1-4
S
100
TACK
Port and System Status LEDs
Condition
On
On
Off
On
On
Green
Flashing
Flashing
On
Off
On
Status
Activity
Status
Switch is receiving power.
Redundant power is on, and the RPU is in
backup or active mode.
Redundant power is off or has failed.
Agent is operational.
Port has established a valid network connection.
Valid 100 Mbps connection.
Port has been partitioned due to an abnormal
network condition, or manually disabled.
Traffic is passing through the port.
Port is operating at full duplex.
Port is operating at half duplex.
Flow control enabled.
1
U