Table of Contents
Advertisement
Figure 3-4. Installing a Module
6. If you are sure the module is properly mated with the connector,
tighten the retainer screws by hand to secure the module in the slot.
7. Connect power to the switch.
Stacking
A stack may have as many as four switches.
Note: A stacking cable is included with the Stack Module.
Caution: DO NOT stack TigerStack 100 units with other devices.
To stack the devices:
1. Locate the stack connectors labeled "UP" and "DOWN" on the stack
modules (see Figure 3-4).
2. Attach one end of the stacking cable to the stack connector labeled
"DOWN" on the top device, and the other end to the connector
labeled "UP" on the next lower device.
3. Repeat this step until all the devices have been connected.
1 0 0
B a s
e - F
X - S
C E
x t e n
d e r
M o d
u l e
S M C
6 9 0
0 F S
C
Doing so may damage the switch.
I
NSTALLING THE
S
WITCH
3-7
Advertisement
Table of Contents
