Table of Contents
Advertisement
A
T
BOUT THE
IGER
Ports Status LEDs
The LEDs, which are located on the front panel for easy viewing, are
shown below and described in the following table.
LED
Gigabit Ethernet Ports (Ports 1~12)
Link/Act
SFP Transceivers Slots
(Ports 9~12)
FDX
(all ports)
1-4
S
10/100/1000
WITCH
Figure 1-2. Port and System LEDs
Port and Status LEDs
Condition
On/Flashing Amber
On/Flashing Green
Off
On Green
Off
On Green
Off
Status
Port has established a valid 10/100
Mbps network connection. Flashing
indicates activity.
Port has established a valid 1000
Mbps network connection. Flashing
indicates activity.
There is no valid link on the port.
Port has established a valid 100 Mbps
network connection.
An SFP transceiver port has no valid
link or there is no transceiver installed
in the slot. The associated RJ-45 port
is enabled.
Port is operating in full-duplex mode.
Port is operating in half-duplex
mode.
Advertisement
Table of Contents
