Configuring Igmp Profile Group; Figure 3-98. Specifying Multicast Port Membership - SMC Networks 6152L2 - annexe 1 Management Manual

C
ONFIGURING THE
Web – Click IGMP Snooping, IGMP Member Port Table. Specify the
interface attached to a multicast service (via an IGMP-enabled switch or
multicast router), indicate the VLAN that will propagate the multicast
service, specify the multicast IP address, and click Add. After you have
completed adding ports to the member list, click Apply.

Figure 3-98. Specifying Multicast Port Membership

CLI – This example assigns a multicast address to VLAN 1, and then
displays all the known multicast services supported on VLAN 1.
Console(config)#ip igmp snooping vlan 1 static 224.1.1.12
ethernet 1/12
Console(config)#exit
Console#show mac-address-table multicast vlan 1
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1
1
Console#

Configuring IGMP Profile Group

Define the access mode and multicast address range for the IGMP profile
group.
Command Attributes
• Profile ID – Selects the IGMP profile to configure.
• Access Mode – Select permit or deny access.
• Current Multicast Address Range List – List of the current
multicast address ranges.
3-216
S
WITCH
224.1.1.12
224.1.2.3
Eth1/12 USER
Eth1/12 IGMP
4-234
4-237