Table of Contents
Advertisement
Configuring IGMP
This protocol allows a host to inform its local switch/router that it
wants to receive transmissions addressed to a specific multicast
group. You can use the IGMP Configuration screen to configure
multicast filtering shown below.
IGMP Status
IGMP Query Count
IGMP Report Delay (Seconds) : 10
<APPLY>
Use <TAB> or arrow keys to move. <Space> to scroll option.
Parameter
IGMP Status
IGMP Query Count
IGMP Report Delay
Note: The default values are indicated in the sample screen.
U
S
SING THE
YSTEM
IGMP Configuration
==================
<OK>
Description
If enabled, the switch will monitor network traffic
to determine which hosts want to receive
multicast traffic. This is also referred to as IGMP
Snooping.
The maximum number of queries issued for
which there has been no response before the
switch takes action to solicit reports.
The time (in seconds) between receiving an IGMP
Report for an IP multicast address on a port
before the switch sends an IGMP Query out that
port and removes the entry from its list.
C
ONFIGURATION
: ENABLED
: 2
<CANCEL>
P
ROGRAM
2-43
Advertisement
Table of Contents
