INSTALLATION INSTRUCTIONS
Scope of delivery
Before installing, check the scope of delivery (Fig. 1) before installation:
1
TV tuner
2
Power cable with integrated fuse (3 A)
3
IR receiver with adhesive pad
4
IR remote control (without batteries)
5
Material to mount TV tuner
Not shown:
• Cable for connection to the handbrake switch
• TV 5100 installation/operating instructions
• Reply card
Accessories
The following original accessories are recommended for operating the TV tuner:
• MA 1210 Y-cable to connect TV tuner to MS 5000 MS navigation system without
MI 5000 multimedia interface (see "TV tuner to PC 5000 computer (in systems
without MI 5000 multimedia interface box)" on page 20)
• TVA 5100 TV tuners (up to 4 antennas can be connected)
Safety precautions
A
Before starting work, disconnect the earth cable from the vehicle battery's negative pole
in order to prevent short circuits. For this purpose, follow the safety instructions of the vehicle
manufacturer (alarm system, airbag, immobiliser, radio coding etc.).
Disconnecting the battery may cause various settings to be erased. Theft protection codes
(e.g. for the radio) may have to entered again after installation (if they were not previ-
ously deactivated).
Modes of installation
Connection of the TV 5100 TV tuner to MS 5000 navigation systems is conducted
independently of whether an MI 5000 multimedia interface box is connected.
Please follow the relevant instructions in the following descriptions as well as the two
different connection diagrams at the end of the booklet.
18