Winding A Bobbin - Singer 4522 Manual

Winding a bobbin
Winding a bobbin is quick and easy when you follow the directions below. Always wind
the bobbin before threading the machine and needle.
. Push in indent (1) on hand wheel disc. This will stop the needle from moving.
. Place spool of thread on spool pin.
. Slide spool- cap (2) firmly over rim of spool to prevent thread tangling.
. Lead thread from spool and snap into thread guide post (3).
. Wind thread clockwise around front of bobbin winder tension disc (4).
. Pass thread end, from Inside, through small hole in rim of bobbin.
* Place bobbin on spindle and push it to the right
. Holding thread end, step on speed controller to run machine until desired amount of thread
is wound. (Winding stops automatically once bobbin is flul)
. Cut thread; push bobbin to the left and remove it from spindle.
. Trim thread end from top of bobbin.
. Return hand wheel disc to sewing position by pressing on side opposite indent.
/ ~ ~~~~2
~
b
l iii
0
18