Table of Contents
Advertisement
To rapidly check the correct direction of the beam,
place the vehicle on flat ground, 10 m away from a
wall. Turn on the low beam, sit on the vehicle and
make sure that the beam projected on the wall is
slightly under the horizontal line of the headlight
(about 9/10th of the total height) (Fig. 47).
To adjust the headlight beam:
Act on the suitable screw (1-Fig. 48) by means of
a screwdriver.
By TURNING IT CLOCKWISE, you set the beam up-
wards.
By TURNING IT ANTICLOCKWISE, you set the
beam downwards.
a
Before changing a bulb, turn the ignition
switch to position "
Change the bulb wearing clean gloves or
using a clean and dry cloth.
a
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage. If you touch
the bulb with bare hands, remove any fingerprint
with alcohol, in order to prevent it from blowing
frequently.
Carefully read p. 41 (MAINTENANCE).
DO NOT FORCE THE ELECTRIC CABLES
m
".
Fig. 47
Fig. 48
65
Hide quick links:
Advertisement
Table of Contents
