Firewall Default Rule (Bridge Mode); Figure 112 Security > Firewall > Default Rule (Bridge Mode) - ZyXEL Communications ZYWALL 2 WG User Manual

Chapter 11 Firewall
Table 69 SECURITY > FIREWALL > Default Rule (Router Mode) (continued)
LABEL
Apply
Reset

11.8 Firewall Default Rule (Bridge Mode)

Click SECURITY > FIREWALL to open the Default Rule screen.
Use this screen to configure general firewall settings when the ZyWALL is set to bridge mode.
See Section 11.1 on page 201
Figure 112 SECURITY > FIREWALL > Default Rule (Bridge Mode)
214
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
for more information about the firewall.
ZyWALL 2WG User's Guide