ZyXEL Communications NSA221 User Manual page 381

Click the Devices tab.
5
Click the Activate button to apply the changes. The following screen displays.
6
Click Yes to save the changes in all screens.
Figure 211 Red Hat 9.0: KDE: Network Configuration: Activate
After the network card restart process is complete, make sure the Status is
7
Active in the Network Configuration screen.
Using Configuration Files
Follow the steps below to edit the network configuration files and set your
computer IP address.
Assuming that you have only one network card on the computer, locate the
1
ifconfig-eth0 configuration file (where eth0 is the name of the Ethernet card).
Open the configuration file with any plain text editor.
• If you have a dynamic IP address, enter dhcp in the BOOTPROTO= field. The
following figure shows an example.
Figure 212 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
NSA221 User's Guide
Appendix A Setting up Your Computer's IP Address
381